Common problems and solutions of screw filter press

 

FAQ 1: Leakage of screw filter press

The problem of sludge leakage is mainly caused by the unsatisfactory flocculation state, or it may be caused by the excessive gap between the rings.

Common problem 2: screw filter press stuck

The state of the stuck shaft is generally caused by the equipment not being cleaned in time or too much dead sludge after running.

Common problem 3: high moisture content of sludge

The cake is not dry, the flocculation tank, the gap of the back pressure plate, and the shaft is too short.

FAQ 4: Motor damage

Find the manufacturer to replace or re-select the motor.

FAQ: 5: Unable to run automatically

Check whether the circuit is abnormal, and find the part that caused the abnormality, check the TS switch.

FAQ 6: Sludge cannot enter the flocculation tank

Check the sludge pump, the high probability is the cause of the sludge pump.

 

Note: You can write to us or leave a message at any time to get technical support or solutions.

Email: info@tnwcn.com

Feedback: Click here