Problems to be paid attention to in the debugging process of screw filter press

 

Problems that should be paid attention to in the process of debugging and maintenance of screw filter press

Generally speaking, the finished product of screw filter press is delivered by the manufacturer to the customer, and the debugging is carried out by the manufacturer.

Problems that engineers should pay attention to during the debugging process:

1. Start-up inspection: First, check whether the screw filter press is in good condition, whether all accessories are in order, including but not limited to whether the electrical and reducer motors are in good condition, check the circuit, and check the basic condition of the machine.

2. Sampling test: take water sample for test, configure the corresponding flocculant, and carry out by professionals.

3. Power-on operation: after the sampling test, power-on operation (on the premise that each pipeline has been connected)

4. Adjustment feedback: According to the mud situation, adjust the set dose. To ensure that the mud meets the needs of Party A.

Problems that engineers should pay attention to during maintenance:

1. The damaged parts should be replaced in time.

2. Adjust the viscosity of sludge in time.

3. Wait for the mud cake to finish.

4. Give Party A correct guidance.

 

Note: You can write to us or leave a message at any time to get technical support or solutions.

Email: info@tnwcn.com

Feedback: Click here